Speed Pot; Key Switch; Throttle Pot; Charger Harness - Golden Technologies Buzzaround XL GB146 Service Manual

Table of Contents

Advertisement

Component: Speed Pot
Location: Mounted on the control panel (12). See #1 on figure 9.
Function: The speed potentiometer (pot) uses variable resistance to control
the speed of the scooter.
Connections: Connected to the main harness through the control panel harness.
Failure Signs: Beep Code #7
Tests: Call Tech Support
Expected readings: Depends on speed pot position.
Serviceable: No. Replace the control panel.
Component: Key Switch
Location: Mounted on the control panel (12). See #2 on gure 9.
Function: Completes the circuit to provide power to the motor.
Connections: Connected to the main harness through the
control panel harness.
Failure Signs: No power when the key is in the ON position.
Tests: Continuity when the key is in the ON position. Make
sure the connector pins are seated properly.
Expected readings: Less than 10 ohms.
Serviceable: No. Replace the control panel.
Component: Throttle Pot (13)
Location: Under the control panel. See #1 on gure 10.
Function: The throttle pot (potentiometer) uses variable
resistance to control speed and direction of travel by varying voltage.
Connections: Connected to the control panel harness (12a).
Refer to figure 11 on page 10.
Failure Signs: Beep Codes #6 and #7.
Tests: Test resistance across the pins 1, 2, and 3 and on 13a.
Expected readings: Depends on direction of de ection.
Serviceable: Replace as necessary.
Component: Charger Harness (14)
Location: Two locations. Inside the battery pack. See #14 on gure 3 on page 5.
Second charger harness located inside the tiller. See figure 11 on page 10.
Function: Connects the charger to the batteries.
Connections: Connected to the battery harness (4a) and the
charger, not shown. Refer to figure 11 on page 10.
Failure Signs: Batteries will not charge.
Tests: Test for voltage and continuity. Check connectors.
Make sure the pins are not corroded and are seated properly.
Expected readings: Continuity (less than 10 ohms).
Serviceable: Replace the harness as necessary.
Buzzaround XL_SG_REVA_100711
1
2
Figure 9. Control Panel (Back)
1
Figure 10. Throttle Pot
8

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Buzzaround xl gb116

Table of Contents