Golden Technologies Buzzaround XL GB146 Service Manual page 41

BEEP CODE #7 - PADDLE FAULT/SPEED CONTROL FAULT (VOLTAGE ERROR)
Remove Remove
the battery
the seat.
pack.
2.5k ohms +/- 10%?
Insert the multimeter probes
into the main harness connector
7a at pin 1 and pin 8 (blue wire
and yellow wire). See figure 23.
Note the resistance reading.
Replace the
controller.
Remove the four
screws that fasten the
controller cover to the
underside of the
scooter frame.
Disconnect the main
harness (7a) from the
controller.
Insert multimeter probes into
the main harness connector
7a at pin 8 and pin 2 (blue
wire and orange wire). See
figure 22.
Are both readings
Yes
within 500 ohms of
each other?
Turn the Set your multimeter to
speed pot to measure resistance.
full rabbit.
Outside that range?
Are either reading outside that range?
Buzzaround XL_SG_REVA_100711
Open the control
panel.
40