Golden Technologies Buzzaround XL GB146 Service Manual page 38

BEEP CODE 5: BRAKE FAULT
Turn the key to the
off position.
Remove Remove the
the seat. battery pack.
80 ohms or less but not shorted?
Replace the
controller.
37
Disengage and then re-
engage the park brake.
Remove the four screws
that fasten the controller
cover to the underside of
the scooter frame.
Measure resistance across pin 1 and
pin 2 on the front intermediate
motor harness (8b) with park brake
engaged.
10 ohms or less?
Go to the next step.
Turn the key to the
on position.
Disconnect the front
intermediate motor
harness (8b) from
the controller.
Make sure that the
pins on 8b are
seated properly.
Check the continuity
between 8b and 9b.
Buzzaround XL_SG_REVA_100711
No
Did the beep
code clear?
Shorted or Open?
Unplug the motor harness (10a)
from the rear intermediate
motor harness (9b).
Make sure that the
pins are seated
properly on 9b.
Yes
OK
Open?