Golden Technologies Buzzaround XL GB146 Service Manual page 44

Check the front intermediate motor harness
and the rear intermediate harness for
continuity.
43
Replace the drivetrain
assembly.
Out of that range?
Replace as necessary.
Open?
Measure resistance across
pin 1 (thick red wire) and
pin 2 (thick black wire) on
10a. See figure 29.
Make sure that the pins are
seated properly on 10a.
Disconnect 10a from 9b if
necessary.
10 ohms or les? Go to the next step.
Buzzaround XL_SG_REVA_100711
Replace the
controller.
50 ohms or less but not shorted?
NOTE: Can be as low as 0.2 ohms.