Main Harness Replacement - Golden Technologies Buzzaround XL GB146 Service Manual

MAIN HARNESS REPLACEMENT

Tools needed: Phillips screwdriver and slotted screwdriver
1. Engage the park brake.
2. Remove the key from the key switch.
3. Remove the seat.
4. Remove the battery pack.
5. Lock the tiller.
6. Remove the control panel shroud. See #1 on gure 36.
7. Remove the four screws that fasten the control panel
to the tiller. See gure 37.
8. Disconnect the main harness (7b) from the control
panel. See #1 on gure 38.
9. Turn the front frame over onto it side.
10. Remove the four screws that fasten the controller
cover to the underside of the scooter frame.
11. Disconnect the main harness (7a) from the controller.
See #1 on gure 35 on page 21.
13. Remove the main harness.
14. Thread the 8-pin connector on the new main harness
through the rubber grommet. See #1 on gure 39.
15. Thread the 8-pin connector on the new main harness
through the tiller.
16. Connect the control panel to the new main harness.
17. Reinstall the control panel onto the tiller.
18. Reinstall the control panel shroud.
19. Connect the 14-pin connector on the new main
harness to the controller.
20. Reinstall the controller cover onto the underside of the scooter frame.
21. Reinstall the battery pack.
22. Reinstall the seat.
1
Figure 39. Tiller Cover Grommet
Buzzaround XL_SG_REVA_100711
Figure 36. Control Panel Shroud
Figure 37. Control Panel Removal
3
1
Figure 38. Control Panel Connectors
1
2
22