ATTACK DPX15 Instructions For Use Manual page 34

END
After the settings are done, the test of device is performed, its correct functionality is checked
and the safety test is made.
34
06 : Disconnection
O
2
TAG
10 : V1 primary air
Air (%) 85
11 : V2 secondary air
Air (%) 40
Function: The boiler for wood burning turn off
after burning out due to
O – indicates higher amount of the rest coal
2
(easier start)
TAG – indicates the minimum rest coal
(recommended by problems with burning –
shapeless or wet fuel)
Producer: O
2
Setting: O /TAG
2
Function: When there is a flue gas sensor or
oxygen fault, it is regulated to the adjusted
value. This is a temporary solution until the
fault is removed – it is not a normal operating
function!
Producer: 85 %
Range for setting: 0 % – 100 %
Function: When there is a flue gas sensor or
oxygen fault, it is regulated to the adjusted
value. This is a temporary solution until the
fault is removed – it is not a normal operating
function!
Producer: 40 %C
Range for setting: 0 % – 100 %