Snowblower Installation - Walker MT Detailed Instructions

6. Install the rotation worm assembly through the tube
weldment with the attaching plate of the support on
the underside of the chute base lip.
Tube
Weldment
Rotation
Worm
Bushing Support
With Attaching Plate
Install Rotation Worm Assembly
7. Install the chute over the plastic insert and secure
with four retaining plates, using two (2) 1/4 x 1/2 in.
bolts, lock washers, and nuts in each of the three
(3) standard retaining plates, and two (2) 1/4 x 3/4
in. bolts, lock washers and nuts in the rear right re-
taining plate which also secures the support.
Torque all bolts to 10 ft-lb. (13.6 N·m).
Retaining
Plate
Install Chute over Plastic Insert
SERVICE INSTRUCTIONS
July 2006
Bushing
Chute
WALKER MANUFACTURING COMPANY
Page: 1-26
8. Insert two (2) 5/16 x 1 in. carriage bolts through
each of the skid shoes from inside the bend. Place
a flat washer, lock washer, and nut loosely on each
bolt and place the bolt heads through the round
holes in the outer ends of the bottom angle of the
snowblower body. Adjust the skid shoes to allow
the required clearance under the cutting edge.
Slide the square shank portion of the bolt head into
the slot and torque to 19 ft-lb (25.8 N·m). Refer to
ADJUSTMENTS of Two-Stage Snowblower Skid
Shoes in Maintenance Instructions.
Snowblower
Housing
Carriage Bolts
Install Skid Shoes

Snowblower Installation

1. Thoroughly clean the drive shaft yoke and install a
1/4 x 1/4 x 1-1/4 in. key in the reduction shaft key-
way.
2. Slide the drive shaft yoke over the reduction shaft.
3. Secure the yoke to the reduction shaft with a 1/4 x
2-1/2 in. bolt and nylon locknut. Tighten the nut
and the 3/8 x 3/8 in. allen set screw securely over
the key in the yoke.
Skid Shoe