Pto Drive Belt - Model Ms - Walker MT Detailed Instructions

PTO Drive Belt - Model MS

1. To remove the PTO drive belt:
a. Remove the engine belt, as described in pre-
vious section.
b. Remove 1/4-20 x 3/4 bolt locating belt guide
on gearbox pulley and rotate guide to clear
belt.
Remove Bolt and Rotate Belt Guide to Clear Belt
Blade Clutch
Lever
Clutch
Actuator Assembly
SERVICE INSTRUCTIONS
Engage Clutch
Clutch Idler Pulley
PTO Belt Tightener
Linkage
PTO Drive
PTO Drive Belt Removal
WALKER MANUFACTURING COMPANY
July 2006
c. Move blade clutch (in direction of engage-
ment) far enough to relax belt scrubber brake
without tightening the PTO drive belt. Roll belt
off PTO drive pulley and GHS blower pulley
(GHS model only).
2. Install the PTO drive belt by reversing the removal
procedure. Check scrubber brake adjustment and
brake action.
Pulley
Belt Scrubber Brake
(Relax Brake to Remove Belt)
Page: 4-12
Compound Pulley
Belt Guide
PTO
Drive Belt
GHS
Blower
Pulley