Battery Installation; Mower Deck Assembly; Deck Caster Wheels Installation; Deck Discharge Deflector Shield Installation - Walker H38i Operator's Manual

Assembly Instructions

Battery Installation

IMPORTANT: Make sure battery is securely mount­
ed in the frame. A loose battery may cause damage
to the case resulting in acid leakage and severe
damage to the machine. A hazard may be created
by damage to critical working parts and safety sys­
tems.
Install the battery in the mower as shown in Battery
Installation photo. Connect the positive (+) first and
then the negative (­) cable to the proper battery ter­
minal [red cable and boot connects to the Posi-
tive (+) terminal]. Slide the rubber boot up and over
the battery post, making sure it covers the post com­
pletely to prevent an electrical short.
Make sure the battery cap vents are open.
Improper venting of the battery COULD
cause a battery explosion.
Battery Clamp
Secured by
Wing Nut(s)
Battery Installation
20
WARNING
(+) Battery Cable
Connection

Mower Deck Assembly

Deck Caster Wheels Installation

1. Remove the bolts and washers from each deck
caster wheel.
2. Install wheel on fork using bolts and washers.
3. Tighten the bolts and washers.
Deck Caster Wheel Installation
Deck Discharge Deflector Shield Installation (DS60)
Attach the side discharge deflector shield using two
(2) 3/8­16 x 1­1/4 in. bolts, 3/8­16 ESNA nuts, and
3/8 in. wave spring washers. The wave washers fit
between the two hinging surfaces. Tighten the nuts
until the shield moves freely but is not loose.
WARNING
DO NOT operate the machine without the
grass deflector shield attached and in the
lowest possible position.
Deck Discharge Shield Installation
Attach Shield