Replacing/Repairing - All Models; Drive Belts - Model Mc, Mt, Mtl; Drive Belts - Model Md; Drive Belts - Model Ms - Walker MT Detailed Instructions

REPLACING/REPAIRING - ALL MODELS

Model MS, MW, MB, MC, MT
DANGER
To prevent accidental starting of the en-
gine when replacing parts or repairing the
machine, remove the key from the ignition
switch and disconnect the spark plug
wire(s).
Model MD
DANGER
To prevent accidental starting of the en-
gine when replacing parts or repairing the
machine, remove the key from the ignition
switch and disconnect the electrical plug
on the fuel shut-off solenoid.
All Models
IMPORTANT: ALWAYS use genuine factory replace-
ment parts. Substitute parts CAN result in product mal-
function and possible injury to the operator and/or
others.

Drive Belts - Model MC, MT, MTL

There are four (4) individual belts on GHS models or
three (3) belts on SD models:
•
Engine PTO Drive Belt (3 Groove Power Band)
•
Jackshaft Drive Belt
•
GHS Blower Drive Belt (GHS Model Only)
•
Hydrostatic Ground Drive Belt
SERVICE INSTRUCTIONS
July 2006

Drive Belts - Model MD

There are five (5) individual belts on GHS models or
four (4) belts on SD models:
•
Engine PTO Drive Belt (3 Groove Power Band)
•
Jackshaft Drive Belt
•
GHS Blower Drive Belt (GHS Model Only)
•
Hydrostatic Ground Drive Belt
•
Engine Fan Belt

Drive Belts - Model MS

There are three (3) individual belts on the machine:
•
Engine Belt
•
PTO Drive Belt
•
Ground Drive Belt

Drive Belts - Model MW

There are two (2) individual belts:
•
Ground Drive Belt
•
PTO Drive Belt (3 Groove Power Band)

Drive Belts - Model MB

There are three (3) individual belts on the machine:
•
Engine/PTO Belt (matched pair)
•
Ground Drive Belt
All Models
The belts may be removed and replaced using the pro-
cedures described on the following pages.
WALKER MANUFACTURING COMPANY
Page: 4-4