Assembly Instructions; Setup Instructions; Tire Installation (Tractor); Battery Service - Walker H27i Operator's Manual

Hide thumbs Also See for H27i:
Table of Contents

Advertisement

Assembly Instructions

Assembly Instructions
It is critical to follow the steps provided for
setup and assembly of the tractor and deck
to ensure the safety of the operator and
performance of the equipment.

SETUP INSTRUCTIONS

Walker Mowers are shipped partially assembled to
our distribution network, and are typically assem-
bled by the selling dealer. For any additional
assembly besides the following, contact your Walk-
er dealer.

Tire Installation (Tractor)

Install the drive tires using the eight (8) mount-
ing nuts supplied with the Owner's Packet of
materials. Nuts are torqued to 75 to 85 lb·ft
(102 to 115 N·m).
Check and adjust the inflation of the tires. The
tire inflation recommendations are:
Drive
=
Tailwheel =

Battery Service

The battery comes sealed and is maintenance-
free, so the electrolyte level will not need to be
checked or filled.
Battery
Battery Location
IMPORTANT: Make sure battery is securely
mounted in the frame. A loose battery may cause
damage to the case resulting in acid leakage and
se vere damage to the machine. A hazard may be
18
WARNING
15 PSI (103 kPa)
20 PSI (137 kPa)
cre ated by damage to critical working parts and
safety systems.
CAUTION
Important Battery Service, Installation, and
Charging Tips for Electronic Fuel Injection
Engines:
Do not allow the battery cables to touch
opposing terminals. When connecting
battery cables attach the positive (+)
cable to positive (+) battery terminal
first, followed by negative (-) cable to
negative (-) battery terminal.
Never start the engine when the cables
are loose or poorly connected to the
battery terminals.
Never disconnect battery while engine
is running.
Never use a quick battery charger to
start the engine.
Never "jump start" the engine using an-
other source. Electricity fluctuations
can damage the ECU (Electronic Con-
trol Unit).
Always disconnect negative (-) battery
cable lead before charging battery, and
also unplug harness from ECU before
performing any welding on equipment.
H27i

Advertisement

Table of Contents
loading

Table of Contents