Assembly Instructions; Setup Instructions; Tire Installation (Tractor); Battery Service - Walker T27i Operator's Manual

Assembly Instructions

SETUP INSTRUCTIONS

Walker Mowers are shipped partially assembled to
our distribution network, and are typically assem-
bled by the selling dealer. For any additional as-
sembly besides the following, contact your Walker
dealer.

Tire Installation (Tractor)

•
Install the drive tires using the eight (8) lug bolts
that are supplied with the Owner's Packet of
materials. Bolts are torqued to 75 to 85 lb
·
(102 to 115 N m).
4-ply; rear tires are 13 x 5.00-6, 4-ply.
•
Check and adjust the inflation of the tires. The
tire inflation recommendations are:
Drive =
Tailwheel =

Battery Service

Raise front mower body up for battery access (refer
to Front Body Latch Release in Operating Instruc­
tions). Check the battery for electrolyte level and
charge. The electrolyte level should be at the bot-
tom of the vent wells [1/4 to 1/2 in. (6 to 13 mm)
above plates]. If the specific gravity is less than
1.225, the battery needs charging. If the battery has
been shipped dry, or is wet but needs service, refer
to the following instructions.
IMPORTANT: Make sure battery is securely mount-
ed in the frame. A loose battery may cause damage
to the case resulting in acid leakage and severe
damage to the machine. A hazard may be created
by damage to critical working parts and safety sys-
tems.
Drive tires are 18 x 9.50-8,
15 PSI (103 kPa)
20 PSI (137 kPa)

Wet Battery Service

If the battery has been shipped wet, but the electro-
lyte level is low or the battery needs to be charged
then:
1. Fill each battery cell with distilled water to the
bottom of the vent wells.
2. Charge battery. Refer to Battery Charging in
this section.

Dry Battery Service

·
ft
Activating a battery can be dangerous.
The battery should be taken to a reliable
service station, battery store, or power
equipment dealer where a trained techni-
cian can activate the battery safely. DO
NOT attempt to activate the battery unless
you are experienced in battery service
work. The following activation and charg-
ing instructions are provided for use by a
trained battery technician.
Battery electrolyte is a poisonous and cor-
rosive sulfuric acid solution.
•
Avoid spillage and contact with skin,
eyes, and clothing - causes severe burns.
•
To prevent accidents, wear safety gog-
gles and rubber gloves when working with
electrolyte.
•
Neutralize acid spills with baking soda
and water solution.
To fill (activate) battery with electrolyte (if battery has
been shipped dry):
1. Remove the battery hold-down bar, disconnect
the battery cables and lift the battery out of the
tray.
DANGER
DANGER
19