Combo Interface; Leds; System Status Led - HP 5130 EI Switch Series Installation Manual

NOTE:
HP recommends that you use HP 1000 Mbps SFP transceiver modules, SFP+ transceiver modules, or SFP+
DAC cables for the SFP+ ports on the switch. The HP 1000 Mbps SFP and SFP+ transceiver modules are
subject to change over time. For the most up-to-date list of SFP and SFP+ transceiver modules, contact your
HP sales representative or technical support engineer.
For more information about the 1000 Mbps SFP transceiver modules, SFP+ transceiver modules, and
SFP+ DAC cables, see HP Comware-Based Devices Transceiver Modules User Guide.
Figure 52 SFP+ DAC cable
1
(1) Connector

Combo interface

The HP 5130-24G-SFP-4SFP+ EI switch provides eight combo interfaces. A combo interface includes an
SFP port and a 10/100/1000Base-T autosensing Ethernet port. Only one of these two ports can operate
at a time.

LEDs

System status LED

The system status LED shows the operating status of the switch.
Table 19 System status LED description
LED mark
SYS
2
Status
Steady green
Flashing green
Steady red
Flashing yellow
Off
(2) Pull latch
Description
The switch is operating correctly.
The switch is performing power-on self test (POST).
The switch has failed POST.
Some ports have failed POST.
The switch is powered off.
49