Combo Interface - HP flexnetwork 5510 hi series Installation Manual

Figure 57 40G QSFP+ DAC cable
1
(1) Connector
Figure 58 40G QSFP+ to 4x10G SFP+ DAC cable
1
(1) QSFP+ module
(3) SFP+ side pull tab
NOTE:
• As a best practice, use HPE QSFP+ transceiver modules, QSFP+ DAC cables, or QSFP+ to 4 x
SFP+ DAC cables for the QSFP+ ports on the switch. The HPE QSFP+ transceiver modules,
QSFP+ DAC cables, and QSFP+ to 4 x SFP+ DAC cables available for the interface cards are
subject to change over time. For the most recent list of QSFP+ transceiver modules, QSFP+
DAC cables, and QSFP+ to 4 x SFP+ DAC cables available for the interface cards, contact HPE
Support or marketing staff.
• You can use a HPE X140 40G QSFP+ MPO SR4 Transceiver or HPE X140 40G QSFP+ MPO
MM 850nm CSR4 300m Transceiver to connect a QSFP+ port to four SFP+ ports. The QSFP+
transceiver module and SFP+ transceiver modules to be connected must be the same in
specifications, including central wavelength and fiber type.
For more information about HPE QSFP+ transceiver modules, QSFP+ DAC cables, and QSFP+ to 4
x SFP+ DAC cables, see HPE Comware-Based Devices Transceiver Modules User Guide.

Combo interface

The HPE 5510 24G SFP 4SFP+ HI switch provides eight combo interfaces. A combo interface
contains an SFP port and a 10/100/1000Base-T autosensing Ethernet port. Only one of these two
ports can operate at a time.
2
2
(2) Pull tab
(2) QSFP+ side pull tab
(4) SFP+ module
61
3
4