Electromagnetic wave radiation.
•
Common impedance (including the grounding system) coupling.
•
To prevent EMI, use the following guidelines:
•
If AC power is used, use a single-phase three-wire power receptacle with protective earth (PE) to
filter interference from the power grid.
Keep the switch far away from radio transmitting stations, radar stations, and high-frequency
•
devices to make sure the EMI levels do not exceed the compliant range.
•
Use electromagnetic shielding when necessary. For example, use shielded interface cables.
To prevent signal ports from getting damaged by over-voltage or over-current caused by lightning
•
strikes, only route interface cables indoors.
Laser safety
WARNING!
Do not stare into any fiber port when the switch has power. The laser light emitted from the optical fiber
might hurt your eyes.
The HP 5130 EI switches are Class 1 laser devices.
Installation tools
Flat-blade screwdriver
•
Phillips screwdriver
•
ESD wrist strap
•
All these installation tools are user supplied.
Installation accessories
Table 3 Installation accessories
Product
code
5066-0850
Description
1 U four-hole mounting
bracket kit (including one
pair of mounting brackets
and eight M4 countersunk
screws)
Quantity
Applicable models
•
HP 5130-24G-PoE+-4SFP+ (370W) EI
•
HP 5130-48G-4SFP+ EI
•
HP 5130-48G-PoE+-4SFP+ (370W) EI
•
HP 5130-24G-SFP-4SFP+ EI
•
HP 5130-48G-2SFP+-2XGT EI
1 kit
•
HP 5130-24G-PoE+-2SFP+-2XGT (370W) EI
•
HP 5130-48G-PoE+-2SFP+-2XGT (370W) EI
•
HP 5130-48G-4SFP+ EI BR
•
HP 5130-24G-PoE+-4SFP+ (370W) EI BR
•
HP 5130-48G-PoE+-4SFP+ (370W) EI BR
4