Connecting The Switch To An Rps; Verifying The Installation - HP 5130 EI Switch Series Installation Manual

Figure 24 Connecting the DC power cord to an HP 5130-24G-SFP-4SFP+ EI switch

Connecting the switch to an RPS

CAUTION:
To connect the switch to an HP RPS, you can only use the power cord that is provided with the RPS.
To connect the switch to an RPS:
1. Correctly orient the plug with the power receptacle on the power supply, and insert the plug into
the receptacle (See callout 1 in
If you cannot insert the plug into the receptacle, re-orient the plug rather than use excessive force
to push it in.
2. Tighten the screws on the plug with a flat-blade screwdriver to secure the plug in the RPS receptacle.
See callout 2 in
3. Connect the other end of the power cord to the RPS.
Figure 25 Connecting an RPS cord to an HP 5130-48G-4SFP+ EI switch

Verifying the installation

After you complete the installation, verify that:
There is enough space for heat dissipation around the switch, and the rack or workbench is stable.
•
Figure
Figure 24.
1
2
24).
2
19
1