Installing And Removing A Power Supply (Hp 5130-24G-Sfp-4Sfp+ Ei Switch) - HP 5130 EI Switch Series Installation Manual

Figure 16 Grounding through the PE wire of the AC power cord
(1) Chassis rear panel
NOTE:
To guarantee the grounding effect, use the grounding cable provided with the switch to connect to the
grounding strip in the equipment room as long as possible.
Installing and removing a power supply (HP
5130-24G-SFP-4SFP+ EI switch)
CAUTION:
Provide a circuit breaker for each power supply and make sure the circuit breaker is off before installation.
The HP 5130-24G-SFP-4SFP+ EI switch provides two power supply slots and comes with power supply slot
1 empty and a filler panel in power supply slot 2. You can install one power supply, or two power
supplies for
5130-24G-SFP-4SFP+ EI switch, see
When two power supplies are installed, you can hot-swap a power supply. To avoid device damage and
bodily injury, follow the procedures in
Figure 17 Installation procedure
安装电源模块 安装电源模块 安装电源模块
Install the power supply
1
redundancy. For information about power
"Appendix B
Connect the power cord
2
(2) Three-wire AC power cable
FRUs."
Figure 17 and Figure 18
连接电源线 连接电源线 连接电源线
14
supplies available
to install and replace a power supply.
Turn on the circuit
给电源模块加电 给电源模块加电 给电源模块加电
breaker
for the HP