Combo Interface; Leds; System Status Led - HP 5130-24G-4SFP+ EI Installation Manual

Product code
JD096C
JD097C
JG081C
NOTE:
HP recommends that you use HP 1000 Mbps SFP transceiver modules, SFP+ transceiver modules, or SFP+
cables for the SFP+ ports on the switch. The HP 1000 Mbps SFP and SFP+ transceiver modules are subject
to change over time. For the most up-to-date list of SFP and SFP+ transceiver modules, contact your HP
sales representative or technical support engineer.
For more information about the 1000 Mbps SFP transceiver modules, SFP+ transceiver modules, and
SFP+ cables, see HP Comware-Based Switches Transceiver Modules User Guide.
Figure 49 SFP+ cable
(1) Connector

Combo interface

The HP 5130-24G-SFP-4SFP+ EI/HP 5130-24G-SFP-4SFP+ EI TAA switch provides eight combo interfaces.
A combo interface includes an SFP port and a 10/100/1000Base-T auto-sensing Ethernet port. Only
one of these two ports can operate at a time.

LEDs

System status LED

The system status LED shows the operating status of the switch.
Table 17 System status LED description
LED mark
SYS
HP description
HP X240 10G SFP+ SFP+ 1.2m DA Cable
HP X240 10G SFP+ SFP+ 3m DA Cable
HP X240 10G SFP+ SFP+ 5m DA Cable
Status
Steady green
Flashing green
Steady red
Flashing yellow
(2) Pull latch
Description
The switch is operating correctly.
The switch is performing power-on self test (POST).
POST has failed.
Some ports have failed to pass POST.
48
Max transmission distance
1.2 m (3.94 ft)
3 m (9.84 ft)
5 m (16.40 ft)