Connecting The Power Cord - HP 5130 EI Switch Series Installation Manual

4. Grasp the handle of the power supply with one hand and pull the module part way out. Support
the module bottom with the other hand, and pull the power supply slowly along the guide rails out
of the slot.
5. Place the removed power supply in an antistatic bag.
Figure 20 Removing a PSR150-A1 power supply

Connecting the power cord

CAUTION:
• Provide a circuit breaker for each power cord.
Before connecting the power cord, make sure the circuit breaker on the power cord is turned off.
•
Table 5 Power cord connection procedures at a glance
Switch model
•
HP 5130-24G-4SFP+ EI
•
HP 5130-24G-2SFP+-2XGT EI
•
HP 5130-24G-4SFP+ EI BR
•
HP 5130-48G-4SFP+ EI
•
HP 5130-24G-SFP-4SFP+ EI
•
HP 5130-48G-2SFP+-2XGT EI
•
HP 5130-48G-4SFP+ EI BR
•
HP 5130-24G-PoE+-4SFP+ (370W) EI
•
HP 5130-48G-PoE+-4SFP+ (370W) EI
1
2
Available power source
AC power source
AC power source
–48 V DC power source in the
equipment room
RPS
Recommended HP RPS models:
A-RPS800 (JD183A ) and
A-RPS1600 (JG136A)
AC power source
16
1
Connection procedure
reference
Connecting the switch to
an AC power source
Connecting the switch to
an AC power source
Connecting the switch to a
–48 VDC power source
Connecting the switch to
an RPS
Connecting the switch to
an AC power source