Installing/Removing A Power Supply - HP FlexFabric 5700-48G-4XG-2QSFP+ TAA Installation Manual

Installing/removing a power supply

WARNING!
The switch does not support intermixing of AC and DC power supplies.
•
HP 5700-48G-4XG-2QSFP+ and HP 5700-48G-4XG-2QSFP+ TAA switches do not support
•
intermixing of 300 W and 650 W power supplies.
• In power redundancy mode, you can replace a power supply without powering off the switch but must
strictly follow the installation and procedures in
damage to the switch.
The switch comes with both power supply slots empty and the power filler modules as accessories.
You can install one or two power supplies for these switches as needed. For more information about the
power supplies available for the switches, see "Power supplies."
Figure 15 Installation procedure
Figure 16 Removal procedure
Installing a power supply
CAUTION:
Follow the forward inertia of the power supply when inserting it into the chassis, and make sure the
•
power supply has firm contact with the connectors on the backplane.
To prevent damage to the connectors inside the switch chassis, insert the power supply gently. If you
•
encounter a hard resistance while inserting the power supply, pull out the power supply and insert it
again.
• If only one power supply is installed, install a power filler module in the empty power supply slot for
good ventilation of the switch.
To install a 300 W AC power supply, 300 W DC power supply, 650 W AC power supply, or 650 W
DC power supply into the switch:
1. Wear an ESD wrist strap and make sure it makes good skin contact and is well grounded.
2. Unpack the power supply and verify that the power supply model is correct.
3. Correctly orient the power supply with the power supply slot (see
the power supply with one hand and support its bottom with the other, and slide the power supply
slowly along the guide rails into the slot.
The slot is foolproof. If you cannot insert the power supply into the slot, re-orient the power supply
rather than use excessive force to push it in.
Figure 15 and Figure 16
18
to avoid any bodily injury or
Figure 17), grasp the handle of