Table of Contents
Advertisement
INSTALLATION
Considerations
The most desirable and beneficial location for a YUNCA JERVOIS HEATER is in the centre of a
building, thereby allowing the most efficient use of the heat created.
The location of windows, doors and the traffic flow in the room where the heater is to be located,
should all be considered.
If possible a location should be selected that allows the flue pipe to be installed simply and pass
through the house without cutting a floor or roof joist.
To obtain maximum heat distribution with any freestanding heater a ceiling fan can be fitted.
Another important consideration when installing the Yunca Jervois is availability of power supply to
the fan.
When the appropriate position has been selected the unit can be bolted to the floor to ensure that the
unit remains upright in the event of an earthquake or similar. If the heater is being attached to a
concrete floor dyna bolts should be used, if the floor is wooden the bolts used should be long enough
to go fully through the floorboards and fixed with nuts and washers from the underside.
The earthquake brackets are located at the front corners of the heater.
19-07-05
Page 4 of 20
Operation Instructions for Jervois Freestanding Gas Heater March 2002
Advertisement
Table of Contents
