Oki MB770dn User Manual page 276

SETTING ITEMS (ADMIN)
2
Press [PEAP] and press [NEXT].
1
2
The WIRELESS AUTHENTICATION (PEAP) screen is
displayed.
3
Enter the following items and press [NEXT].
3
4
• [EAP USER NAME]
Press this to enter the EAP user name that is used for the
authentication.
• [EAP PASSWORD]
Press this to enter the EAP password that is used for the
authentication.
• [RETYPE PASS]
5
Press this to enter the EAP password again that you
enter in the EAP PASSWORD field.
Memo
• When pressing each button, the letter entry screen is
displayed. Enter the value using the keyboard and
digital keys, and press [OK] to set the entry.
6
4
Specify the following items and press
[NEXT].
7
• ENCRYPTION BETWEEN AP AND STA.
Select the encryption type that is used for the
communication between Access Point and this
equipment.
[TKIP] — Select this to use TKIP encryption. TKIP
provides a different key for per packet with a message
integrity check. This key will be changed for every fixed
interval.
[AES(CCMP)] — Select this to use AES encryption. AES
is the next-generation cryptography algorithm that the
U.S. government improves to replace the DES and
3DES.
[DYNAMIC WEP] — Select this to use an encryption
which automatically updates the WEP key. DYNAMIC
WEP does so periodically as well as automatically.
Note
• To select [TKIP] or [AES (CCMP)], press [WPA] or
[WPA2], or to select [DYNAMIC WEP], press [802.1X].
Memo
• The encryption intensity between each encryption is:
AES(CCMP) > TKIP > DYNAMIC WEP
5
Specify the following items and press
[NEXT].
• TRANSMIT POWER
Select the low transmit power if you want to limit the area
that the wireless communication is enabled. If you do not
have to limit the area, select [100%].
6
Confirm the settings and press [FINISH].
Memo
• If you want to change the settings, press [PREV] to
move back to the screen that you want to change and
then repeat the operation.
- 276 -