Oki MB770dn User Manual page 133

ORIGINAL MODE
Set the scanning mode based on the type of the original.
TEXT: This is suitable for an original with text
and line drawings.
TEXT/PHOTO: This is suitable for an original with a
mixture of text and photos.
PHOTO: This is suitable for an original with
photos.
Memo
• In the TEXT/PHOTO mode or PHOTO mode,
transmission time may be longer than in the TEXT
mode.
TX TYPE
Set the fax transmission mode.
MEMORY TX: Send the original after the scanned
data are saved in the memory. Up to
100 transmissions of up to 1000
pages per 1 transmission can be
reserved.
DIRECT TX: Send the original directly as it is being
scanned. Once a page has been
scanned and sent, the next page is
scanned and sent. Therefore, it takes
longer to scan and send all pages.
However, you can confirm on the fly
that each page is sent to the recipient.
SECURE RECEIVE FORCED SETTING
You can enable or disable the SECURE RECEIVE
function.
This is available only when the WEEKLY SCHEDULE
function is set.
ENABLE: This enables the SECURE RECEIVE function.
Memo
• It becomes disabled at the time set by WEEKLY
SCHEDULE.
DISABLE: This disables the SECURE RECEIVE function.
Memo
• It becomes enabled at the time set by WEEKLY
SCHEDULE.
• An administrator password is required.
EXPOSURE
Set the density at which the original is to be scanned.
AUTO: This equipment automatically detects
the contrast of the original, and scans
it with the optimum contrast.
MANUAL: Press
contrast.
or to set the desired
- 133 -
TTI
Switch the TTI recording ON or OFF. To enable this
feature, the Terminal ID must be registered to this
equipment in advance.
P.134 "Registering the terminal ID"
Memo
• Setting this item may not be required since it may not
be displayed on the screen (it depends on your
country or region).
RTI
Switch the RTI recording ON or OFF. To enable this
feature, the Terminal ID must be registered to this
equipment in advance.
P.134 "Registering the terminal ID"
ECM
Switch the ECM (Error Correction Mode) communication
ON or OFF.
ECM is an internationally standardized communication
mode that automatically corrects errors that occur during
fax transmissions. With this setting option ON, even when
the transmitted data have been affected by noise during
communication, this mode allows good communication
without image distortion by automatically resending the
part that have been affected.
Memo
• Both the sender and the receiver must have the ECM
function to make ECM communication available.
• When affected by noise during communication,
communication time is slightly longer than usual. Even
when the ECM communication is used, an error may
occur depending on the line status.
• The ECM communication is not available for voice
communication.
PREVIEW SETTING
Switch the preview setting ON or OFF.
INITIAL PREVIEW TYPE
Set the preview type to be displayed as an initial
SETTING ITEMS
1
2
3
4
5
6
7