Installation Instructions - Fisher & Paykel RB90S64MKIW Service Manual

840653
3

INSTALLATION INSTRUCTIONS

For further information regarding the installation of the product, refer to the copy of the Installation
Instructions supplied with it.
The CoolDrawer MUST be installed to allow for future removal from the enclosure if service is required. Do
not seal this CoolDrawer into the cabinetry with silicone or glue. Doing so will make future servicing difficult.
Fisher & Paykel will not be liable for any costs associated with removing or replacing a sealed-in product, nor for
repairing any damage that may be incurred by doing this.
Care should be taken when the appliance is installed or removed to reduce the likelihood of damage to the
power supply cord.
Failure to install the CoolDrawer correctly will invalidate any warranty or liability claims.
If the power supply cord is damaged, it must be replaced. Parts are available from an Authorised Fisher &
Paykel dealer.
Cabinetry must be sufficiently robust to support a combined product and food load of 100 kg (220 lb). Bearers
may be required to support the internal shelf.
Before installing the CoolDrawer, please make sure that:
The switched power outlet must be outside the refrigerator drawer cavity so that it is accessible after
installation.
The switched power outlet must be located outside the cavity, within 1400mm (55") from the CoolDrawer
cavity if situated on the left-hand side of the cavity and within 840mm (33") if situated on the right-hand side of
the cavity.
The services hole in the refrigerator cavity needs to be large enough for the power supply plug to fit through.
8