Page 3
SAFETY AND WARNINGS READ AND SAVE THIS GUIDE WARNING! General Use Electric Shock Hazard Keep this installation guide with your user guide for future reference. Failure to follow this advice may result in When using any microwave oven generating heat, there are certain safety precautions you electric shock or death.
SAFETY AND WARNINGS Remove all packing materials from inside the microwave drawer. Do not remove the waveguide cover, which is located on the top of the microwave drawer (see illustration on below for waveguide cover location). Remove the feature sticker, if one is present. Check the drawer for any damage, as a misaligned or bent drawer, damaged drawer seals and sealing surfaces, broken or loose microwave drawer guides and dents inside the cavity or on the front side of the drawer, If there is any damage, do not operate the microwave drawer and contact your dealer or...
PRIOR TO INSTALLATION COMPONENTS REQUIRED Ensure that: PARTS The countertop and oven cavity are square and level, and are the required dimensions. ● Keep all packaging materials until the unit has been inspected. The installation will comply with all clearance requirements and applicable standards and ●...
PRODUCT DIMENSIONS Model no: OMD24SDB1 Product Dimensions inch a Overall height 15 15/16" B Overall width 23 7/8" c Overall depth 23 5/16" d Height of chassis 14 3/4" e Width of chassis 21 15/16" f Depth of chassis 21 3/4" g Height of control panel 3 1/16"...
Page 7
PRODUCT DIMENSIONS Model no: OMD24SPX1 Product Dimensions inch a Overall height 15 15/16" B Overall width 23 7/8" c Overall depth 23 5/16" D Height of chassis 14 3/4" e Width of chassis 21 15/16" f Depth of chassis 21 3/4"...
CABINETRY DIMENSIONS PROUD INSTALL 3/4"(19mm) 1 9/16" (40mm) PROFILE PLAN FLUSH INSTALL CABINETRY DIMENSIONS INCHES 5/8 -13/16" A Minimum inside height of cavity flush 16 1/16 (16 -20mm) B Minimum inside height of cavity proud 15 9/16 C Overall width of cabinetry D Overall height of cabinetry flush 17 9/16 E Overall height of cabinetry proud...
Page 9
MODEL CODE VOLTAGE (V) AMPS (A) OMD24SPX1, OMD24SDB 60 Hz 120 V Model and serial number location Open the microwave drawer fully. The label is beyond the back wall of the microwave cavity...
Page 10
ANTI-TIP BLOCK INSTALLATION To reduce the risk of tipping of the drawer, the anti-tip block must be correctly installed, located 14 13/16" (377mm) above the cabinetry floor on which the microwave drawer will sit. • The 6" (152mm) anti-tip block must be provided by the installer. If the microwave drawer is to be moved, •...
DRAWER INSTALLATION Place the drawer adjacent to the wall or Secure the drawer using the 4 x 7/8" cabinet opening. Plug the power supply (22mm) screws supplied. cord into the electrical outlet. Carefully guide the drawer into the cavity. Avoid pinching the cord between the oven and the wall.
INSTALLER CHECKLIST Read all installation guidance in this document to see if the unit has been correctly installed. Ensure that installation has been completed correctly before use. TO BE COMPLETED BY THE INSTALLER Installation Electrical Ensure the microwave drawer is level and securely fitted to the cabinetry. ...