Replacement Of Interior Lamps; Removal Of Drawer Tray; Removal Of Decorative Front Panel - Fisher & Paykel RB90S64MKIW Service Manual

12.3.2

Replacement Of Interior Lamps

The three LEDs are part of a PCB board that is
clipped into place behind the lens cover. To remove
the PCB board:
• Disconnect the refrigerator from the power
supply.
• Remove the lens cover with the aid of a small flat
bladed screwdriver.
• Remove the PCB.
• Unclip the wiring harness plug.
Replace in reverse order.
12.3.3

Removal Of Drawer Tray

• Open the drawer.
• Remove the bins from the drawer.
• Slide inwards the two retaining clips at the rear of
the drawer tray.
• Lift the drawer tray out.
Refit in reverse order.
12.3.4

Removal Of Decorative Front Panel

• Open the drawer slightly.
• Loosen the screw located in the centre behind
the bottom edge of the drawer front.
• Pull the panel out slightly at the bottom.
• Lift and pull out from the top edge.
Refit in reverse order.
Harness plug
Retaining
clips
57
840653