Drawer Front Tilt Adjustment - Fisher & Paykel RB90S64MKIW Service Manual

• Slide the rail covers on each side back from the front of the
rails by lifting slightly underneath.
• Use a 10 mm spanner to back off the centre bolt away from
the drawer front.
• The drawer front can now be lifted off the drawer slides.
Note: The drawer front could be heavy.
12.3.9

Drawer Front Tilt Adjustment

Parallel alignment between the drawer front and cabinet is very important to ensure good drawer /gasket
sealing. The drawer front may require adjustment to compensate for the weight of the drawer panel, or it
may have moved with time and use.
The steps to adjust drawer front tilt are:
Preparation.
• Refer to the Installation Instructions to ensure familiarity with the CoolDrawer installation method.
• Remove the lower false panel.
• Remove the side installation trims by pulling them forward.
• Unscrew the four trim brackets from the cabinetry.
• Remove the aluminium tray and bins from the product.
• Slide the product forward out of the cabinetry to reveal the gasket seal when the door is closed.
• Slide the grey covers at the front of the drawer rails back to expose the door adjustment screws. The
covers are clipped to the drawer, so it helps to pull these at the bottom and top.
• Using a 3/8" (10mm) spanner, back off the centre locking screws.
3/8" Locking screw
1/2" Tilt adjusting screws
Adjusting drawer front tilt.
• Using a 1/2" (13mm) spanner, wind the top or bottom screws in or out to align the door so that it is
parallel with the cabinet.
• If the top screws are already wound in, then the top of the drawer front can be tilted towards the cabinet
by winding the bottom screws out.
• When adjusted, the front edge of the door side should be 4-5mm from the cabinet front face at the top
and bottom of the drawer.
Drawer front panel
Adjusting screw
59
840653
Rail cover
Lift and slide to rear