part number526607 0
08/2006
(page 1 of 12)
I
®
ishDrawer
TALLATI
I
T U TI
(NOTE:FORINTEGRATED P ANELPREPARATION INSTRUCTIONS R EFER TO SUPPLIED SHEET)
DOUBLEDD603 MODELS
DD603 PREFINISHED
(shownleft)
DD603 FLAT DOOR (notshown)
DD6031 INTEGRATED (shownright)
SINGLE DS683 MODELS
DS603 PREFINISHED
(shownbft}
DS603 FL£ DOOR (not shown}
DS6031 INTEGR£ED (shownright}
NOTE TO THEiNSTALLER
1. Read these instructions completely and carefully.
2.
installation of this DishDrawer® requires basic
mechanical and electrical skills.
3.
Be sure to leave these instructions with the Customer.
4.
At the completion of the DishDrawer® installation, the
installer must perform Final Check List as per Section 12
of these installation instructions.
5.
Remove all packaging materials supplied with the
DishDrawer®.
6.
This dishwasher is manufactured for indoor use only.
NOTE TO THECUSTOMER
Keep these Installation Instructions with your User Guide
for future reference. The DishDrawer® must be securely
anchored before # is operated.
Z_WARNING!
Before installing the BishBrawer@
, remove the house fuse or open
the circuit breaker. Ensureall water connectionsare turned OFF.It is
the responsibilityof the plumber andelectrician to ensure that each
installationcomplieswith all Codesand Regulations.
Important!
These instructions must be followed precisely
to ensure correct
venting and operation of the BishBrawer®
. In the event of a fault
related to the incorrect installation, the installer will be liable for any
repairs.
important!
The BishBrawer®
MUST be installed
to allow for future removal
from the enclosure
ff service
is required.
important!
improperinstallationis not covered under the Warranty.
Important!
if the BishBrawer® is to be relocated from one installation to
another it must be kept upright to avoid damage from water spillage.