Removal Of Lower Front Access Panel; Removal Of Front Chassis Cover; Removal Of Display Module/User Interface; Removal Of Drawer Front Panel - Fisher & Paykel RB90S64MKIW Service Manual

840653
12.3.5

Removal Of Lower Front Access Panel

• Remove the decorative front panel.
• Remove the three screws securing each side
of the lower front access panel.
• Lift the panel clear.
Refit in reverse order.
12.3.6

Removal Of Front Chassis Cover

• Disconnect the refrigerator from the power
supply.
• Remove the lower front access panel (refer to
Section 12.3.5).
• Remove two screws securing each side of the
front chassis cover.
• Remove the earth wire from the tab on the
rear of the cover.
• Lift the cover clear.
Refit in reverse order.
12.3.7

Removal Of Display Module/User Interface

The display module/user interface is supplied as a complete assembly with the printed circuit board and
glass user interface as one unit.
• Disconnect the refrigerator from the power supply.
• Remove the decorative front panel (refer to Section 12.3.4).
• Remove the left hand top end cap holding the display module/user interface assembly to the top edge of
the drawer.
• Slide the assembly 12mm (½") to the right to clear the right hand top end cap from the frame, and lift.
• Unplug the harness from the module.
Refit in reverse order.
12.3.8

Removal Of Drawer Front Panel

• Disconnect the refrigerator from the power
supply.
• Open the drawer.
• Remove the drawer tray (refer to Section
12.3.2).
• Using
a small
connector cover on the right-hand side.
• Unplug the connector from the drawer front.
screwdriver, unclip the
58
Screws
Screws
Rail cover
Connector cover