Table of Contents
Advertisement
Installation (for qualified installers only)
Electrical Requirements
Plug the power cord into a grounded 120 Volt outlet (do not remove the grounding pin).
The appliance, when installed, must be electrically grounded in accordance with local codes or, in the
absence of local codes, with the National Electrical Code, ANSI/NFPA 70, or the Canadian Electrical
Code, CSA C22.1.
Clearances
Due to the high temperature of the heater, it should be located out of traffic and away from furniture and draperies.
S ide
k
Wall
l
Mantel Clearances
The maximum mantel depth is 12" (305mm).
NOTE: The combustible area above the facing must not protrude more than 3/4" (20mm) from the facing.
If it does, it is considered a mantel and must meet the mantel requirements listed in this manual.
Above Base of Insert (n)
© Travis Industries
n
m
p
x
37"+(940mm+)
36"(915mm)
35"(889mm)
Mantel Height
34"(864mm)
33"(839mm)
32"(813mm)
31"(788mm)
k Sidewall to Insert
l Side Facing
(non-combustible)
m Top Facing*
(non-combustible)
n 12" Mantel*
(combustible or
non-combustible)
n 4" Mantel*
(combustible or
non-combustible)
p Hearth Extension
to the Front
x Extension onto
Hearth
* Measured from the base of the insert.
NOTE: the non-combustible top facing
must extend 35.5" (902mm) above the
base of the insert or to the bottom of the
mantel (whichever is less).
Maximum Mantel Depth
4051112
11
Minimum
Clearances
6"
153mm
5"
127mm
35.5"
902mm
36.5"
928mm
33"
839mm
12"
305mm
0"
0mm
100-01271_000
Advertisement
Table of Contents
