Table of Contents
Advertisement
Optional Equipment (for qualified installers only)
9. Replace the firebox components. Restore the fireplace to the correct configuration. Install the
firebacks before re-installing the burner.
10. Access the stepper motor (shown below). The stepper motor (adjustable regulator) has an
installation sheet included with it – make sure to follow all of the directions. Disconnect the wiring
from the stepper motor. Remove the stock stepper motor and replace with the LP version. – MAKE
SURE IT IS CORRECTLY ORIENTED. Secure using the screws included with the motor – tighten to
25 Lb-inches. Leak test this area after installation to verify proper installation. Re-attach the wiring.
11. Restore the appliance to the correct configuration. Make the gas line connection, bleed the gas line
(if applicable), start the heater and thoroughly leak-test all gas connections and the gas control valve.
© Travis Industries
4051112
51
100-01271_000
Advertisement
Table of Contents
