Table of Contents
Advertisement
48
Optional Equipment
LP Conversion Instructions
WARNING
This conversion kit shall be installed by a qualified service agency in accordance with the
manufacturer's instructions and all applicable codes and requirements of the authority
having jurisdiction. If the information in these instructions is not followed exactly, a fire,
explosion or production of carbon monoxide may result causing property damage, personal
injury or loss of life. The qualified service agency is responsible for the proper installation
of this kit. The installation is not proper and complete until the operation of the converted
appliance is checked as specified in the manufacturer's instructions supplied with the kit.
Packing List
Convert the appliance prior to installing the gas line to ensure proper gas use.
Note: This change is only applicable for NG units. On LP, any orifice gaskets are removed and
discarded.
1. Access the firebox.
2. Remove the burners (see "Remove the Burner," in the owners manual).
3. Remove and discard the two existing orifice gaskets (see "a" below).
4. Install the new 1"x1" gasket (see "b" below).
NOTE: The hole in the shorter gasket is not in exact center. Make sure to install the shorter gasket
with the longer end at the bottom.
5. Bend and install the new 2¾" gasket (see "c" below).
© Travis Industries
(for qualified installers only)
LP
(2) LP Seal Plates
Orifices
b
4051112
c
100-01271_000
Advertisement
Table of Contents
