DFI LANParty Jr. GF9400 T2RS User Manual page 73

Power Management
This field allows you to select the type (or degree) of power saving
by changing the length of idle time that elapses before the Suspend
mode and HDD Power Down fields are activated.
Min Saving
Max Saving
User Define
HDD Power Down
This is configurable only when the Power Management field is set to
User Define. When the system enters the power saving time set in
this field, the hard disk drive will be powered down while all other
devices remain active.
HDD Down in Suspend
The default setting is Disabled. When enabled, the hard drive will be
powered off once the system enters the Suspend mode.
Soft-Off by PWR-BTTN
This field allows you to select the method of powering off your
system.
Delay 4 Sec. Regardless of whether the Power Management func-
tion is enabled or disabled, if the power button is
pushed and released in less than 4 sec, the system
enters the Suspend mode. The purpose of this func-
tion is to prevent the system from powering off in
case you accidentally "hit" or pushed the power but-
ton. Push and release again in less than 4 sec to
restore. Pushing the power button for more than 4
seconds will power off the system.
Instant-Off Pressing and then releasing the power button at
once will immediately power off your system.
Minimum power saving time for the Suspend
Mode (1 hour) and HDD Power Down (15
min.)
Maximum power saving time for the. Suspend
Mode and HDD Power Down = 1 min.
Allows you to set the power saving time in the
"Suspend Mode" and "HDD Power Down" fields.
3
BIOS Setup
73