DFI LANParty Jr. GF9400 T2RS User Manual page 13

The system board is equipped with an IrDA connector
for wireless connectivity between your computer and pe-
IrDA IrDA IrDA IrDA IrDA
ripheral devices. The IRDA (Infrared Data Association)
specification supports data transfers of 115K baud at a
distance of 1 meter.
The system board supports USB 2.0 and USB 1.1 ports.
USB USB USB
USB USB
USB 1.1 supports 12Mb/second bandwidth while USB
2 . 0 2 . 0
2 . 0 2 . 0 2 . 0
2.0 suppor ts 480Mb/second bandwidth providing a
marked improvement in device transfer speeds between
your computer and a wide range of simultaneously accessible exter-
nal Plug and Play peripherals.
This feature allows the system that is in the Suspend
W W W W W ak ak ak ak ake e e e e
mode or Soft Power Off mode to wake-up/power-on to
O n O n
O n O n O n
respond to calls coming from an external modem or
Ring Ring Ring
Ring Ring
respond to calls from a modem PCI card that uses the
PCI PME (Power Management Event) signal to remotely wake up
the PC.
Important:
If you are using a modem add-in card, the 5VSB power source
of your power supply must support a minimum of ≥ 720mA.
This feature allows the network to remotely wake up a
W W W W W ak ak ak ak ake e e e e
Soft Power Down (Soft-Off) PC. It is supported via the
O n O n O n
O n O n
onboard LAN port or via a PCI LAN card that uses
L L L L L AN AN AN AN AN
the PCI PME (Power Management Event) signal. How-
ever, if your system is in the Suspend mode, you can power-on the
system only through an IRQ or DMA interrupt.
Important:
The 5VSB power source of your power supply must support
≥ 720mA.
This function allows you to use the PS/2 keyboard or
W W W W W ak ak ak ak ake e e e e
PS/2 mouse to power-on the system.
O n O n O n
O n O n
PS/2 PS/2
PS/2 PS/2 PS/2
Important:
The 5VSB power source of your power supply must support
≥ 720mA.
1
Introduction
13