DFI LANParty Jr. GF9400 T2RS User Manual page 68

3
BIOS Setup
KB Power On Password
Move the cursor to this field and press <Enter>. Enter your pass-
word. You can enter up to 5 characters. Type in exactly the same
password to confirm, then press <Enter>.
The power button will not function once a keyboard password has
been set in this field. You must type the correct password to power-
on the system. If you forgot the password, power-off the system and
remove the battery. Wait for a few seconds and install it back be-
fore powering-on the system.
Hot Key Power On
This field is used to select a function key that you would like to use
to power-on the system.
Onboard FDC Controller
Enabled
Disabled
Onboard Serial Port
Auto
3F8/IRQ4, 2F8/IRQ3, 3E8/IRQ4, 2E8/IRQ3
Disabled
Onboard IRDA Select
3F8/IRQ4, 2F8/IRQ3, 3E8/IRQ4, 2E8/IRQ3
Disabled
IR Mode Select
This field is used to select the type of IrDA standard supported by
your IrDA device. For better transmission of data, your IrDA periph-
eral device must be within a 30
meter.
68
Enables the onboard floppy disk controller.
Disables the onboard floppy disk controller.
The system will automatically select an I/O ad-
dress for the onboard serial port.
manually select an I/O address for the onboard
serial port.
Disables the onboard serial port.
manually select an I/O address for the onboard
IrDA.
Disables the onboard IrDA.
o
angle and within a distance of 1
Allows you to
Allows you to