Error Code And Self-Diagnostic Mode - Toshiba e-STUDIO351c Service Handbook

2.

ERROR CODE AND SELF-DIAGNOSTIC MODE

2.1 Error Code List
The following error codes is displayed at the upper right of the screen when the "CLEAR PAPER" or "CALL
SERVICE" symbol is blinking.
2.1.1 Jam
Error code Classification
E010 Paper exit jam
E020 Paper exit jam
E030 Other paper jam
E061
E062
E063
E064
E065
E090
June 2005 © TOSHIBA TEC
Contents
Jam not reaching the exit sensor : The paper which
has passed through the fuser unit does not reach
the exit sensor.
Stop jam at the exit sensor: The trailing edge of the
paper does not pass the exit sensor after its leading
edge has reached this sensor.
Power-ON jam: The paper is remaining on the
paper transport path when power is turned ON.
Incorrect paper size setting for upper drawer: The
size of paper in the 1st drawer differs from size set-
ting of the equipment.
Incorrect paper size setting for lower drawer: The
size of paper in the 2nd drawer differs from size set-
ting of the equipment.
Incorrect paper size setting for PFP upper drawer:
The size of paper in the 3rd drawer differs from size
setting of the equipment.
Incorrect paper size setting for PFP lower drawer:
The size of paper in the 4th drawer differs from size
setting of the equipment.
Incorrect paper size setting for bypass tray: The
size of paper in the bypass tray differs from size
setting of the equipment.
Image data delay jam: Image data to be printed
cannot be prepared.
e-STUDIO281c/351c/451c ERROR CODE AND SELF-DIAGNOSTIC MODE
2 - 1
Troubleshooting
P. 5-1
P. 5-2
P. 5-18
P. 5-18
P. 5-18
P. 5-18
P. 5-18
P. 5-18
P. 5-19
2