Firmware Updating With Download Jig - Toshiba e-STUDIO351c Service Handbook

6.1

Firmware Updating with Download Jig

In this equipment, it is feasible to update the firmware automatically by connecting the download jig
using the dedicated connector and turning ON the equipment.
The download jig consists of the ROM, in which the program is written, and the jig board.
Two types of the download jigs are available for each type of the firmware.
For updating the firmware, in addition to the current ways such as updating each firmware individually,
the batch update of the firmware of the equipment is available (except the hard disk and the option).
Firmware
System ROM
Engine ROM
Scanner ROM
RADF ROM
Finisher ROM
(Finisher firmware)
Finisher ROM
(Saddle stitcher firmware)
Hole punch unit ROM
(Hole punch unit firmware)
FAX ROM
Refer to the following for the details to update with each download jig.
P. 6-4 "6.1.1 PWA-DWNLD-350-JIG2 (48 MB)"
P. 6-20 "6.1.3 K-PWA-DLM-320"
e-STUDIO281c/351c/451c FIRMWARE UPDATING
Stored
System control PC board
(SYS board)
* The system firmware is
stored into the hard disk
from the FROM basic sec-
tion software version
"V1.01/2.30".
Logic PC board
(LGC board)
Scanning section control PC
board
(SLG board)
RADF control PC board
(MR-3018)
Finisher control PC board
(MJ-1101/MJ-1023/MJ-1024)
Finisher control PC board
(MJ-1024)
Hole punch control PC board
(MJ-6101)
FAX board (GD-1200)
6 - 2
06/08
Download jig
Batch update
PWA-DWNLD-350-JIG2
(48 MB)
<Two download jigs are
needed.>
-
-
-
-
-
Individual update
-
K-PWA-DLM-320
K-PWA-DLM-320
K-PWA-DLM-320
K-PWA-DLM-320
K-PWA-DLM-320
K-PWA-DLM-320
K-PWA-DLM-320
June 2005 © TOSHIBA TEC