Toshiba e-STUDIO351c Service Handbook page 586

If the USB storage device is not recognized properly, the following message is displayed. In this
case, disconnect the USB storage device and connect it again within 3 minutes, or turn OFF the
power of the equipment and connect the device properly. Then repeat the procedure from (5).
If the updating data file does not exist or a data file for other model is stored, the following mes-
sage is displayed. In this case, turn OFF the power of the equipment and confirm if the data file
stored in the USB storage device is correct. Then repeat the procedure from (5).
Note: Note:
"If you still want to continue, Please Push Start Key" will not be displayed if the FROM basic sec-
tion software version of the equipment is "V1.01 / 2.30" or later.
e-STUDIO281c/351c/451c FIRMWARE UPDATING
Fig. 6-46
Fig. 6-47
6 - 42
06/08
June 2005 © TOSHIBA TEC