Gas Connection - Falcon Toledo TXT110DFSSEU Instructions For Use And Installation

Make sure you lower BOTH REAR ROLLERS. There are two
adjusting nuts, one for each roller, at both the front bottom
corners of the cooker.
Unfold the rear edge of pack base tray. Carefully push the
cooker backwards into position. Take care not to damage
the power cable. Push the cooker close to its final position,
leaving just enough space to get behind it.
Levelling
You are recommended to use a
spirit level on a shelf in one of
the ovens to check for level.
Place the cooker in its intended
position taking care not to twist
it within the gap between the
kitchen units as damage may
occur to the cooker or the units.
The rollers can be adjusted to
level the cooker. To adjust the
height of the rear of the cooker
use the levelling tool supplied
to turn the adjusting nuts at
the front bottom corners of the
cooker.
Adjust the height of the front
roller to level the cooker. Turn
clockwise to raise the cooker
and anticlockwise to lower.
Check the appliance is electrically safe and gas sound when you have finished.
INSTALLATION
When you are satisfied with the height and level, raise the
front of the cooker by one turn of the front roller adjuster.
Screw down the front feet to meet the floor. Screw the front
roller adjuster anticlockwise to raise the front roller so that
the front of the cooker is supported on the feet, not the
front roller, to prevent accidental movement of the cooker.
Leave the levelling tool in the storage drawer, so that the
customer can use it if they wish to move the cooker.

Gas Connection

Restraining device
A restraining device should be fitted when the cooker is
connected to a flexible gas supply. Any restraining device
should be secured to the fabric of the building and should
be able to be released so that the cooker can be pulled out
for cleaning and maintenance.
Flexible Gas Hose
A gas shut off valve must be fitted between the gas supply
and the connection hose. The flexible hose (not supplied
with the cooker) must be in accordance with the relevant
standards. If in doubt contact, your supplier.
The rear cover boxes limit the position of the supply point.
The house gas supply needs to terminate with a down
facing connection.
The appliance connection is located just below hotplate
level at the rear of the cooker. ('A' in the figure)
The inlet connection on the cooker is ISO 7-1 internal. If you
require a ISO 228-1 connection find the ISO 7-1 to ISO 228-
1 connector in the conversion kit. Apply a suitable thread
sealing compound to the ISO 7-1 end.
46