Advertisement
Thank you for purchasing the Cable Column Attachment. This piece is part of the Body-Solid line
of quality strength training machines, which let you target specific muscle groups to achieve
better muscle tone and overall body conditioning.
This Attachment will fit onto the:
G2B
G3S
G5S
G6B
G10B
These instructions show the Cable Column
Attachment being attached to only one gym.
Because of the design of these gyms is simular,
the Cable Column Attachment will fit.
When you attach the Cable Column Attachment,
leave all nuts and bolts hand tight, untill the last
step is complete. Then go back and wrench
tighten all nuts and bolts.
CAUTION: To set up this unit, you will need assistance.
You must review and follow the instructions in this Owner's Manual. If you do not assemble and use
according to these guidelines, you could void the Body-Solid warranty.
CAUTION:
Obtain assistance.
Review the Installation Requirements before
proceeding with the following steps.
Installation Requirements:
Set up on a solid, flat surface. A Smooth, flat
surface under the machine helps keep it level. A
level machine has fewer malfunctions.
Provide ample space around the machine.
Open space around the machine allows for
easier access.
Before You Begin
I
2
Unpacking the Equipment
Each piece is carefully tested and inspected
before shipment. Body-Solid ships the unit in
several pieces that require assembly. Ask for
assistance during the assembly process.
Carefully unpack the boxes and lay the pieces
on the floor near the area where you plan to use
the equipment.
Be careful to assemble all components in the
sequence presented in this guide.
If any items are missing, contact the dealer from
whom you purchased the unit or call Body-Solid
Customer Service at 1-800-833-1227.
NOTE: With so many assembled parts, proper
alignment and adjustment is critical. While
tightening the nuts and bolts, be sure to leave
room for adjustments.
Insert all bolts in the same direction. For
aesthetic purposes, insert all bolts in the same
direction unless specified (in text or illustrations)
to do otherwise.
Leave room for adjustments. Tighten fasteners
such as bolts, nuts, and screws so the unit is
stable, but leave room for adjustments. Do not
fully tighten fasteners until instructed in the
assembly steps to do so.
Fill out and mail warranty card.
Advertisement
