Advertisement
S T E P
2
Be careful to assemble all components in the
sequence they are presented.
NOTE:
Finger tighten all hardware in this step. Do Not wrench tighten until the end of step 6.
A.
Insert two Nylon Bushings (2) into Adjustable Pulley Holder (D) as shown.
Slide Adjustable Pulley Holder (D) onto Chrome Upright (C) and hold in place
with Flat Pop Pin (3).
B.
Attach two Double Pulley Pivots (E) and (F) to the Adjustable Pulley
Holder (D) using:
Two 12 (1/2" x 6 1/2" hex head bolt)
Four 34 (1/2" washer 1" O.D.)
Two 30 (1/2" nylon lock nut)
C.
Attach Convex End Cap (1) onto Top Frame Attachment (G), slide Top Frame
Attachment (G) into Top Frame Clamp (H).
Clamp Top Frame Clamp (H)* to the top of your gym above the weight stack as
shown using:
One 16 (3/8" x 3" hex head bolt)
Two 21 (3/8" washer)
One 31 (3/8" nylon lock nut)
*NOTE:
There are no holes to bolt the Top Frame Clamp (H) onto your unit, so clamp this
piece around the frame.
D.
Attach Top Frame (J) to Top Frame Attachment (G) using:
Two 15 (3/8" x 2 1/2" hex head bolt)
Two 22 (3/8" spring lock washer)
Two 21 (3/8" washer)
E.
Attach Top Frame (J) and Plastic Pulley Wide (6) to Chrome Upright (C) using:
One 16 (3/8" x 3" hex head bolt)
One 17 (3/8" x 5" hex head bolt)
Four 21 (3/8" washer)
Two 31 (3/8" nylon lock nut)
Attach Convex End Cap (1) onto Top Frame (J) as shown.
MM
Inch
8
Advertisement
