Advertisement
S T E P
3
Be careful to assemble all components in the
sequence they are presented.
NOTE:
Finger tighten all hardware in this step. Do Not wrench tighten until the end of step 6.
A.
Remove the Curved End Cap, Metal Plate, and hardware from the top of your gym.
Attach Top Support Attachment (K) to the top of your gym as shown using:
Two 16 (3/8" x 3" hex head bolt)
Three 21 (3/8" washer)
One 31 (3/8" nylon lock nut)
B.
Slide the open end of Top Frame Support (L) around Top Support Attachment (K).
Attach Top Frame Support (L) to Top Frame (J) as shown using:
One 15 (3/8" x 2 1/2" hex head bolt)
Two 21 (3/8" washer)
One 31 (3/8" nylon lock nut)
Attach Top Frame Support (L) to Top Support Attachment (K) as shown using:
One 16 (3/8" x 3" hex head bolt)
Two 21 (3/8" washer)
One 31 (3/8" nylon lock nut)
C.
Attach two Plastic Pulley (5) to Top Frame (J) as shown using:
One 18 (3/8" x 5 3/4" hex head bolt)
Two 21 (3/8" washer)
Two 8 (spacer)
One 31 (3/8" nylon lock nut)
Attach one Plastic Pulley (5) to the flanges on the bottom of Top Frame (J) using:
One 14 (3/8" x 1 3/4" hex head bolt)
Two 21 (3/8" washer)
One 31 (3/8" nylon lock nut)
D.
Attach four Plastic Pulley (32) to the two Double Pulley Pivot (E) and (F) using:
Four 10 (1/2" x 2 1/4" hex head bolt)
Eight 20 (1/2" washer)
Four 30 (1/2" nylon lock nut)
E.
Attach Plastic Pulley Wide (6) to the bottom of Chrome Upright (C) using:
One 17 (3/8" x 5" hex head bolt)
Two 21 (3/8" washer)
One 31 (3/8" nylon lock nut)
MM
Inch
10
Advertisement
