Advertisement
S T E P
5
Be careful to assemble all components in the
sequence they are presented.
NOTE:
Finger tighten all hardware in this step. Do Not wrench tighten until the end of step 6.
NOTE:
The picture on page 15 is from the reverse angle, from the back of the gym.
A.
Route Cable (9) up to the angled Pulley (5), this is the Pulley hanging from
Top Frame (J), and route Cable over Pulley. When routing over this pulley,
insert the cable over the pulley from back to front. The front being the side the
Top Wide Pulley is on.
B.
Route Cable down and through Double Pulley Holder (M), and hold in
place by installing a second Small Pulley (4).
C.
Route Cable (9) up to Pulley (5), this is the Pulley on the back side of
Top Frame (J), and route over Pulley as shown on page 15.
Make sure the cable is parallel to itself, and not crossing. If necessary
switch the cable between the two pulleys inside Double Pulley Holder (M).
D.
Route Cable Down and under Wide Pulley (6) at the bottom of Chrome
Upright (C).
Route Cable up and through Double Pulley Pivot (E) as shown on page 15.
Remove and reinstall pulleys as needed.
MM
Inch
14
Advertisement
