Advertisement
S T E P
6
Be careful to assemble all components in the
sequence they are presented.
A.
Disconnect your gym's small cable from the Main Support Frame of your
gym and the hook at the bottom of the free floating pulley. Discard this cable.
B.
Connect Cable (35) to the hook at the bottom of the free floating pulley of your
gym. Route Cable (35) through the two pulley flanges on top of Main Base
Frame (A).
C.
Attach two Plastic Pulleys (5) to Main Base Frame (A) on top of Cable using:
Two 14 (3/8" x 1 3/4" hex head bolt)
Four 21 (3/8" washer)
Two 31 (3/8" nylon lock nut)
D.
Connect Cable (35) to the bottom of Double Pulley Holder (M). By wrench
tightening the threaded end of Cable (35) into the bottom of Double Pulley
Holder (M) using the Spring Lock Washer (38) and Lock Nut (39) that is
packaged in a seperate bag marked:
"Use to attach Cable 35 to Double Pulley Holder (M)."
E.
Go back and wrench tighten all hardware.
MM
Inch
16
Advertisement
