Table of Contents
Advertisement
Mounting and commissioning the machine
8
Fitting the reel stand
.01.04
8
Commissioning
.02
●
●
●
●
●
●
8
Switching the machine on / off
.03
●
●
●
26
Fig. 8 - 04
Clean the machine thoroughly and then check the oil level ( see Chapter 12 Care and
Maintenance ).
Check the machine, in particular the electric leads and pneumatic connection tubes, for
any damage.
Have mechanics ensure that the machine's motor can be operated with the available
electricity supply.
Connect the machine to the compressed air system. The manometer should show a
pressure of 6 bar.
If necessary, set this value ( see Chapter 12.05 Checking / adjusting the air pressure ).
Before the machine is commissioned, the seam pattern sizes set in the machine control
unit must be checked, see Chapter 8.04 Setting the seam pattern size.
Switch on the air supply for the button sorting unit, see Chapter 7.02 Switch and regula-
tor for the button sorting unit.
Switch on the main switch, see Chapter 7.01 Main switch.
Switch on the button sorting unit and set the button feed speed, see Chapter 7.02
Switch and regulator for the button sorting unit.
To switch off the machine, the above sequence must be carried out in the re-
verse order.
Fit the reel stand as shown in Fig. 8 - 04.
●
Afterwards insert the stand in the hole in
●
the table top and secure it with nuts pro-
vided.
Advertisement
Table of Contents
