Nimbus Water Systems WIMI6200 User Manual page 67

3.6 Operation of USB port
The USB port operation is applied to both WiMi6200T and WiMi6200R
IP configuration of the WiMi6200T and WiMi6200R through the USB port

 Create both a
memory stick.
 The
FACTORY_DEFAULT=YES : This line must be located at first line of the file.
ipaddr=192.168.0.161
netmask=255.255.255.0 : Sub-net Mask of the WiMi6200T
gatewayip=192.168.0.1 : Gateway IP address of the WiMi6200T
PEER_IP=192.168.0.162 : IP address of the peer device (WiMi6200R)
# Comments of the above configurations
 The
FACTORY_DEFAULT=YES : This line must be located at first line of the file
ipaddr=192.168.0.162
netmask=255.255.255.0 : Sub-net Mask of the WiMi6200R
gatewayip=192.168.0.1 : Gateway IP address of the WiMi6200R
PEER_IP=192.168.0.161 : IP address of the peer device (WiMi6200T)
 Insert the USB memory into the USB port of the WiMi6200T, and recycle the
power.
 Wait for 3~4 seconds until the LED stops the fast blinking, and after stop fast
blinking the USB memory
Note: The USB memory must be removed from the WiMi6200T/R once the fast
blinking of LEDs
Note: The character "#" in the beginning of the line will ignore the rest of text on the
same line.
Note: If there is only "FACTORY_DEFAULT=YES" in the file, then it will work as the
factory reset operation.
Distributed by Pera Systems, Inc.
config.tx and a
config.tx file must include below text
: IP address of the WiMi6200T
config.rx file must include below text
: IP address of the WiMi6200R
must be removed
stops.
Page 66
config.rx files on the root directory of the USB
from the WiMi6200T/R.
WiMi6200 User's Manual
v1.2