Nimbus Water Systems WIMI6200 User Manual page 30

 This DIP switch is used to set the system identification number of the
 There can be maximum 4 receivers, which can display same A/V data from
 This setting has no meaning in LAN mode.
 Wi-Fi Ch.
 This DIP switch is used to set the SSID of the WiMi6200RW. The changes of
 This setting must be same with the setting of the WiMi6200TW.
 In case of wireless multicast mode, this setting of DIP switch must be same
 A specific setting this DIP switch to
 The mode change from Wi-Fi mode to LAN mode will be effective on the fly,
Distributed by Pera Systems, Inc.
WiMi6200RW system when the WiMi6200TW/RW was configured to wireless
multicast mode through the web page.
the one transmitter.
the DIP switch setting will be effective on the fly during operation.
with the WiMi6200TW.
WiMi6200RW system to the LAN mode. And the change of DIP switch setting
from position to other positions shown on table-2 in section 1.5.1
will switch the system to Wi-Fi mode with specific SSID and frequency.
but the change from LAN mode to Wi-Fi mode will reboot the WiMi6200R.
Page 29
WiMi6200 User's Manual
position switches the
v1.2