8
MAINTENANCE & LUBRICATION
8.1 MAINTENANCE & LUBRICATION CHARTS ________________________________
Interval
First 50 hours
Each day
10 hours
Each week
Every 50 hours
End of season
Every 1000
hours
A = Lift Arm Pivot, B =Cutting Unit Pivot, C = Cutting Unit Bearing Housing, D = Steering Ram
Engine Oil (with filter)
Hydraulic Oil (with filter)
Radiator Coolant
Fuel (Fairway 250)
Fuel (Fairway 305)
Fuel (Fairway 405)
Observe the following for service and maintenance.
The lubricating oil change intervals listed in the table below are for classes CF, CE & CD lubricating oils of API
classification with a low sulphur fuel in use. If a CF-4 or CG-4 lubricating oil is used with a high-sulphur fuel,
change the lubricating oil at shorter intervals than recommended in the table above depending on the operating
condition.
en-57
MACHINE MAINTENANCE CHART
Item
Change Hydraulic Charge Filter Element
Check Safety Interlock System.
Check Hydraulic Fluid Level
Check Tyre Pressure
Check Engine Bay for Dirt
Check for Loose Components.
Check for Hydraulic Leaks.
Check Battery Condition.
Change Hydraulic Oil and Filter
Lubricate all Grease fittings each week
Ball Joint, (see the diagram)
FLUID REQUIREMENTS
Quantity
6.4 litres
37.9 litres
6.8 litres
45.4 litres
45.4 litres
45.4 litres
Type
10W 30
Total Equivis ZS 46
50% Anti-Freeze
No 2-D (ASTM D975) Diesel
No 2-D (ASTM D975) Diesel
No 2-D (ASTM D975) Diesel
Section
8.5
7.2
8.5
4.2
8.10
8.10
8.10
8.9
8.5