Operation; Daily Inspection - Jacobsen Fairway 250 JGZZ250 Operation And Maintenance Manual

7

OPERATION

7.1 DAILY INSPECTION ____________________________________________________

1. Do a visual inspection of the vehicle and look for indication of wear, loose hardware. Check for any
components that are not included on the machine or damaged. Check for fuel and oil leaks to make sure
that all connections are tight. Make sure that all hoses and tubes are in good condition.
2. Check the fuel supply, radiator coolant level, crankcase oil level and air cleaner is clean. All fluids must be
at the full mark with the engine cold.
3. Make sure all cutting units are adjusted to the same height of cut.
4. Check all tyres for the correct pressure.
5. Test the operator presence and safety interlock system.
en-45
CAUTION
The Inspection Must Be Done Each day
When The Engine Is Turned Off And All
Fluids Are Cold. Lower The Cutter
Equipment To The Ground, Engage the
Parking Brake, Stop the Engine And
Remove the Ignition Key.