Maintenance And Lubrication Charts; Maintenance Chart - Jacobsen LF557 Safety, Operation & Maintenance Manual

8 MAINTENANCE AND LUBRICATION CHARTS

8.1

MAINTENANCE CHART

8Maintenan ce and Lub ricatio n Charts
Interval
First 50 Hours
Each day (10 Hours)
Each week (50 Hours)
Each Two weeks (100
Hours)
Each month (250 Hours)
Each two months (400
Hours
Each 500 hours
Yearly
50 Hour Grease Fittings
A - Mower Pivot (1 per cutting unit)
B - Lift Arm Pivot (2 per cutting unit)
C - Lift Cylinders (2 per cutting unit)
D - Steering Cylinder (2)
E - Steering pivot (2)
F - Steering ball joint (2)
G - Rear Axle Pivot
en-43
Mower Service Interval Chart
• Replace engine oil
• Replace engine oil filter
• Replace hydraulic oil filter
• Check steering system
• Check electrical wiring
• Check fan belt tension
• Check Safety Interlock System
• Check engine oil level
• Check engine coolant level
• Check hydraulic fluid level
• Check tire pressure
• Clean radiator and screens
• Lubricate all mower grease fittings
• Check fuel lines and fittings
• Check for loose components
• Check air filter
• Check fan belt tension
• Drain water from fuel system
• Lubricate all reel grease fittings
• Inspect hydraulic hoses and tubes
• Check engine exhaust system
• Check steering system
• Check electrical wiring
• Lubricate reel motor coupler splines
• Replace engine oil and filter
• Replace fuel filter
• Replace fan belt
• Replace hydraulic oil and filter. (500 hours or yearly,
whichever comes first)
• Replace air filter
• Replace radiator antifreeze
• Lubricate wheel bearings (2WD Units)
Item
100 Hour Grease Fitting
H - Reel Bearing Cavity (2 per cutting unit)
J - Rear Roller (2 per cutting unit)
K - Front Roller (2 per cutting unit)
L - Drive shaft (3)
Section
See Section 9.4
See Section 9.4
See Section 9.14
See Section 10.3
See Section 9.20
See Section 10.2
See Section 7.2
See Section 9.4
See Section 9.13
See Section 9.15
See Section 8.2
See Section 9.6
See Section 9.5
See Section 10.2
See Section 9.7
See Section 8.2
See Section 9.12
See Section 9.10
See Section 10.3
See Section 9.20
See Section 9.4
See Section 9.7
See Section 10.2
See Section 9.13
See Section 9.5
See Section 9.17